BasicLinux 3M内存就可以用的linux

Starting BasicLinux
~~~~~~~~~~~~~~~~~~~
Unzip BL3-5x.zip to the C:\baslin directory. The directory must be called baslin, and it must be a top directory (not a sub-directory of another directory).

If you have less than 8mb RAM, you must activate swap memory. You do this by unzipping swap.zip (in C:\baslin).

To start BL3, type BOOT and press the ENTER key.

Problem?
~~~~~~~~
To boot correctly, BL3 needs a relatively clean DOS. If BL3 refuses to boot (or it crashes when you try to run X), start your DOS without extras: no CONFIG.SYS, no AUTOEXEC.BAT, no Windows.

PCMCIA (optional)
~~~~~~
BL3 is able to use standard PCMCIA cards (but not cardbus cards).
To activate a PCMIA card, insert it in the slot and then execute: /etc/pcmcia/start

Networking (optional)
~~~~~~~~~~
If you have a suitable ethernet card, you can utilize it in BasicLinux.
The steps are outlined in the file “netsetup” (in the /root directory).
Just edit “netsetup” to match your situation and execute it.

If you have a suitable modem, you can run pppsetup to configure a dial-up connection to your Internet Service Provider. Note: many of the modems in Windows computers are designed to work only with Windows — they do not
work with BasicLinux.

Installing BasicLinux to an ext2 partition (optional)
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
From inside BL3, use fdisk and mke2fs to create a Linux partition on your
harddisk. Mount that partition at /hd and execute install-to-hd.

Disclaimer
~~~~~~~~~~
BasicLinux is free software. I have done my best to make it error-free, but there is no guarantee regarding its fitness for any purpose. You use it at your own risk.

BasicLinux 3 is designed for old PCs with limited RAM. It is not suitable for mission-critical systems and should not be used on systems containing irreplacable data.